Printronix MVP Series User Manual

Page 33

2–11

Installation

Table Top Mounting

The MVP–Series printers can be mounted on a sturdy table instead of the

pedestal. However, the table must be designed or modified to accommodate

the printer paper path and proper air ventilation.

Select a table sturdy enough to support the weight of the printer. If the

table is not designed for a bottom feed paper path and proper air

ventilation modify the table.

Make sure the four rubber feet are firmly attached to the base of the

printer.

Position the printer on the table so the paper will feed from under the

table, through the paper path slot, and up into the paper guide of the

printer. The paper should pass through the slot with 1/2 inch clearance at

both ends.

Assemble the paper tray (if used) according to the instructions in

“Assembling the Paper Tray” on page 2–8, and position it behind the

printer. Push the ground cable connector onto the protruding metal tab

located on the back of the printer, to the right of the power connector.