Printronix MVP Series - Manual (Page 41)

Operation 3–7
F/L
Purpose Sets forms length from 3.0 to 24.0 inches in 0.5 increments. Verifies proper
forms length when changing paper. See page 4–36 for proper configuration.
See page 3–17 for the procedure to set the forms length.
Status The indicator is always off, you must press to activate.
Action Press and release to display current length.
To select desired forms length, press and release to advance by 0.5
increments. Press and hold for rapid advance. Display cycles from 03.0 to
24.0 inches.
Result After selecting print mode, press and release 2nd FUNC to print with the
selected forms length.
ADDR
Purpose Selects and changes the configuration address in the numeric display
(00 – 99).
Status The indicator is always off, you must press to activate.
Action Press and release to display current two–digit memory address code.
To select desired address, press and release to advance by 01 increments.
Press and hold for rapid advance. Display cycles from 00 to 99.
Result After selecting the desired print test, press and release 2nd FUNC to print
the selected table or test pattern.
Other See page 9–10 for the Self–Test Procedure.
Refer to page 4–3for the Configuration Change Procedure.
DATA
Purpose Selects one of up to nine options (.0 – .9) for each configuration address.
Status The indicator is always off, you must press to activate.
Action Refer to page 9–10 for the Self–Test Procedure.
Refer to page 4–3for the Configuration Change Procedure.