Printronix MVP Series - Manual (Page 44)

Operation 3–10
Removing the Ribbon
To remove the ribbon refer to the illustrations in “Loading the Ribbon,” and
perform the following steps.
1. Move the forms thickness adjustment lever to the base of the printer as
far as it will go. (If the power is on, the CHK indicator will flash when
you move the lever back.) The ribbon mask in back of the ruler will
separate slightly.
2. Release the locking latch on one hub and lift the spool.
3. Carefully remove the ribbon from around the ribbon guides and out of
the ribbon mask.
4. Remove the second spool from its hub.