Printronix MVP Series - Manual (Page 227)

B–2 Appendix
Table B–1. Fault Code Chart
Check
Indicator Fault
Code Fault
Description Corrective
Action
Flashing 011 No paper Load paper
Flashing 012 Forms thickness lever
open; shuttle assembly
cover off or out of place. Close lever; replace or reseat
shuttle cover.
Flashing 014 Shuttle jam Remove jammed paper or
straighten ribbon.
Flashing 015 Shuttle not up to speed Remove any jammed paper;
straighten ribbon; or check that
forms thickness lever is in cor-
rect position.
Steady 030
031
032
040
033
041
050
051 Printer memory:
checksum or pattern
check. These are ”soft”
faults. None, but can be bypassed. Keep
a log of these codes and when
they occur for your field service
representative.
Steady 060 Power supply: +30/+12
voltage failure None. Call an authorized service
representative.
Steady 061 Power supply: –16/–12
voltage failure None. Call an authorized service
representative.
All switch
indicators On
or Off None Data processor
malfunction None. Call an authorized service
representative.
Clear Check Condition
After all faults are corrected:
1. Press CHK to clear the fault condition (CHK indicator will go out).
2. If applicable, press RDY to place the printer on–line.