Siemens SIMATIC PANEL PC 877 - Manual (Page 128)

Maintenance and service
12.4 Installing and removing hardware components
SIMATIC Panel PC 877
12-14
Operating instructions, Release 07/2006, A5E00877780-01
Inserting the slider
To insert the slider:
How to install a module holding-down device
1 Push the slider through the
guide slot until it is seated
firmly on the module. Insert
the module into the slot.
Caution
Do not apply any pressure to the module Therefore, do not apply excessive force to the
slider when you push it onto the module.
2 Cut off the rest of the slider:
Use a knife to notch the slider
at the upper edge of the
bracket and then break this
section off. Cut off the residual
element using a sharp side
cutter.