Sierra Wireless EV-DO - Manual (Page 99)

Global Positioning System (GPS)
Rev 3.0B Feb.08 94
Figure 9-23: AceManager : *PPFLUSHONEVT
NMEA Configuration
Messages Over-The-Air (Remote)
To configure the PinPoint‐E to send NMEA reports to a remote
server, you will need to set 3 commands: *PPIP, *PPPORT, and
*PPGPSR.
a. Set *PPIP and *PPPORT to the IP address and port of
the server to which you want the reports sent.
Figure 9-24: AceManager : PinPoint - *PPIP/*PPPORT
b. Set the GPS Report Type (*PPGPSR) to your preferred
NMEA sentence format.
Figure 9-25: AceManager : PinPoint - *PPGPRSR
• E0 ‐ NMEA GGA and VTG sentences.
• E1 ‐ NMEA GGA, RMC, and VTG sentences.
Local Host
Local reports are sent to the local IP address of the computer or
device connected to the serial port of the PinPoint‐E using PPP.
To configure the modem to send to the local IP, you will need
to set 3 commands: *S53, *PPLATS, and *PPLATSR.
a. Set the port (S53) to the local port to which you want
the reports sent. The local IP address will automati‐