Sierra Wireless EV-DO - Manual (Page 137)

Configuration Commands
Rev 3.0B Feb.08 132
*UDPLAST=n
Note: *UDPLAST does not
change the S53 setting in
NVRAM. If the modem is reset,
the original S53 setting will be
restored from NVRAM. If enabled, sets S53 to the last accepted IP address through
UDP auto answer. This can be used in conjunction with MD3
so that when there is no UDP session, new ethernet host data
will cause a connection to be restored to the last IP accepted
through UDP auto answer.
• n=0 : Does not change S53 setting. (Default).
• n=1 : Set S53 to the last accepted IP.
*USD=n
Waits the specified delay before sending the first UDP packet
and the subsequent UDP packets out to the port Ethernet.
• n=0 : No UDP packet delay (Default).
• n=1 ‐ 255 : Delay in 100ms units, from 100 ms to 25.5 sec.
DNS
This group includes commands specific to the modem being
able to use domain names instead of IP addresses for other
configuration options.
Figure 1-9: AceManager : DNS
*DNSn=d.d.d.d
Queries the DNS addresses. Your cellular carrier provides the
DNS addresses while your modem is registering on their
network.
• n=1 or 2 : First and second DNS address.
• d.d.d.d=IP address of domain server.
*DNSUPDATE=n
Indicates whether the modem should send DNS updates to the
DNS server specified by *DNSUSER. These updates are as per
RFC2136. They are not secure and are recommended only for a
private network. In a public network, the IP Logger services
should be used instead.
• n=0 : DNS updates disabled (Default).
• n=1 : DNS updates enabled.