Sierra Wireless EV-DO - Manual (Page 55)

Configuring your PinPoint-E
Rev 3.0B Feb.08 50
4. Connected
Figure 5-16: HyperTerminal : TCP/IP connected
a. If you are prompted for a password, enter 12345.
Tip: You will not be prompted for a password if you connect using a
COM port.
b. Type AT and press Enter. You should get a reply of
“OK” or “0”.
c. To see what you are typing as you type it, you will
need to turn on the echo and verbose mode. Type
ATE1V1 and press Enter.
d. If you get a reply of “OK”, then you entered the
command successfully. If you get a reply of “0” or
“ERROR”, try entering the command again.
AT Commands
When using a terminal application, you will need to manually
type in each command.
• For most commands, when you are entering them using a
terminal connection, you will need to preface the
command with AT (exceptions are noted), i.e. ATA which
is listed as A.
• Some commands have specific parameters while other
commands will take whatever you type.