Sierra Wireless EV-DO - Manual (Page 143)

Configuration Commands
Rev 3.0B Feb.08 138
Note: It may take up to 30 seconds for the hardware module to
respond after CONNECT is output.
*CSX1=n
PassThru Echo : Echo data to the host.
• n=0 : Data will be passed to the host.
• n=1 : PASSTHRU mode will echo all host received data
and will not pass the data to the modem while the modem
is not asserting DCD.
Note: If the modem is asserting DCD, data will be passed from the
host to the modem as it normally is when *CSX1=0.
*PTINIT=string
Any AT Command string to be passed to the OEM module
before entering PASSTHRU mode, e.g. AT&S1V1, etc.
• string=AT command(s)
*PTREFRESH=n
Number of minutes of inactivity in PASSTHRU mode to
resend the *PTINIT string to the hardware module.
• n=0 : Disabled
• n=1‐255 minutes
*RESETPERIOD=n
In PASSTHRU mode, modem will be reset after this period if
no data has been sent or received. Value is in hours.
• n=0 : Disabled
• n=1‐255 hours
SMTP
SMTP (Simple Mail Transfer Protocol) is the de facto standard
for email transmission across the Internet. The PinPoint‐E can
send messages using SMTP if it has been configured to use a
mail server.
Note: You cannot send an Email with your PinPoint-E unless the
Email server you have configured allows your PinPoint-E as a relay
host. Talk to your network administrator to ensure you can send email
through the email server using your PinPoint-E.