Sierra Wireless EV-DO - Manual (Page 91)

Global Positioning System (GPS)
Rev 3.0B Feb.08 86
• 11 ‐ Global Positioning System (GPS) data.
• 12 ‐ GPS data with the UTC time and date.
• 13 ‐ GPS with time and date and Radio Frequency data
from the antenna.
• D0 ‐ Xora reports.
• E0 ‐ NMEA GGA and VTG sentences.
• E1 ‐ NMEA GGA, RMC, and VTG sentences.
• F0 ‐ TAIP data
• F1 ‐ TAIP compact data
Tip: The PinPoint-E can be configured to supply one type of report to
a remote host and a different report type locally through the serial port
at same time. However, there may be conflicts due to the local and
remote reporting being in different modes and not all features to both
modes may be available.
Sending Reports Automatically
Remote
You can configure the PinPoint‐E to send reports based on a
time interval and on the movement of a vehicle (based on it’s
position from one time to the next).
Figure 9-7: AceManager : PinPoint - *PPTIME, *PPDIST, *PPTSV,
*PPMINTIME
• *PPTIME ‐ Location report sent every set time interval
(seconds).
• *PPDIST ‐ Location report sent only if the position is more
than the set distance (x 100 meters).
• *PPTSV ‐ Location report sent if the vehicle has been in
one location (stationary) for more than a set time interval
(minutes).
• *PPMINTIME ‐ Location report sent be sent at no less
than this time interval (seconds).
Note: If you’re implementing both a time interval and distance interval
for reports, the PinPoint-E will use the timer which expires first. The
reporting interval can impact your data usage. If the interval is set
frequently, you may want to have a high usage or unlimited data plan.