Sierra Wireless EV-DO - Manual (Page 142)

PinPoint-E EV-DO
137 20070914
• n=1 : Private IP Mode: When the Host initiates a 1x
connection, the host will be given the IP address specified
in *HOSTPRIVIP. The modem will then perform 1 to 1
NAT‐like address translation, which shields the Host from
network IP changes.
*HOSTPW=string
Host Password for PAP, CHAP, or PPPoE.
• string=password
*HOSTUID=string
Host User ID for PAP, CHAP, or PPPoE.
• string=user id (up to 64 bytes)
PassThru
PassThru Mode is used to communicate directly to the
PinPoint‐E internal hardware.
Caution: While the modem is in PassThru mode, ALEOS is disabled.
If you need to connect to the PinPoint-E while it is in PassThru mode,
you will need to do so with a terminal application. Not all commands
are available while the modem is in PassThru mode.
Figure 1-12: AceManager : PassThru
\APASSTHRU
Note: This mode is not available
through the remote AT telnet
server. You will need to connect
to the PinPoint-E with it
connected directly to your
computer. Sets the modem operation to pass through mode. This mode
will pass any characters received on the port Ethernet directly
to the internal hardware module and output any characters
from the internal hardware module out the port Ethernet. This
allows direct access/configuration of the hardware module.
Once this mode is entered, the unit must be physically reset to
return to normal operation. This command is not available in
AceManager.