Sierra Wireless EV-DO - Manual (Page 158)

PinPoint-E EV-DO
153 20070914
• n=2 : Grouped Reports. Data is stored until the desired
minimum number of reports (see *PPSNFM) has been
stored. The data is then sent to the server in groups with at
least the specified number of reports.
*PPSNFM=n
Store and Forward Minimum Reports. Specifies the minimum
number of reports that must be stored before they are
forwarded to the server. The data is then sent to the server in
packets that contain at least this number of reports.
• n=0‐255
*PPSNFR=n
Store and Forward Reliability: GPS reports will be retrans‐
mitted if not acknowledged by the server.
• n=0 : Disabled
• n=1 : Reliable mode enabled for RAP messages
• n=2 : Simple reliable mode
*PPTAIPID=nnnn
Sets/queries the TAIP ID. This ID is returned in TAIP reports if
it has been negotiated with the TAIP client. This value is only
used in conjunction with TAIP emulation mode (*PPGPSR=F0).
• nnnn=TAIP ID (4 characters)
*PPTCPPOLL=n
Specifies the port to listen on for TCP GPS report polling. The
request to this port needs to come from the same IP address in
*PPIP.
• n=0 : Disabled
• n=1‐65535 (default 9494)
*PPTIME=n
GPS Report Time Interval. See also *PPMINTIME, *PPTSV,
+CTA.
• n=seconds (1 ‐ 65535)
Note: Your cellular carrier may
impose a minimum transmit time. Caution: A report time of less than 30 seconds can possibly keep an
RF link up continuously. This will eventually cause the PinPoint-E to
overheat and shutdown. An RF resource may continue be tied up to
transfer small amounts of data. Generally the RF channel will be
released and go dormant in 10-20 seconds of no data sent or
received.