Sierra Wireless EV-DO - Manual (Page 157)

Configuration Commands
Rev 3.0B Feb.08 152
*PPMAXRETRIES=n
*PPMINTIME=n
Specifies the minimum amount of time between reports
generated due to either the time interval (*PPTIME) or the
distance interval (*PPDIST). This is useful to limit network
traffic and make more efficient use of bandwidth. This can be
used in conjunction with store and forward. The minimum
value which this setting can take depends on the policies of the
carrier.
• n=0 : Disabled
• n=1‐65535 seconds
*PPODOM=n
Enable odometer reporting.
• n=0 : Disabled (default)
• n=1 : Enabled
*PPODOMVAL=n
The current odometer value of the PinPoint‐E. The value is in
meters. Maximum value is approximately 4.3 billion meters
(2.5 million miles). 1 mile is approximately 1600 meters.
• n=meters
*PPPORT=n
Port where GPS reports are sent.
• n=1‐65535
*PPSNF=n
Store and Forward will cause GPS reports to be stored up if the
PinPoint‐E goes out of network coverage. Once the vehicle is in
coverage the GPS reports will be sent en masse to the server.
• n=0 : Disabled
• n=1 : Enabled (default)
*PPSNFB=n
Store and Forward Behavior. When *PPSNF=1, the type of
Store and Forward behavior is defined by:
• n=0 : Normal Store and Forward. Data is stored when the
PinPoint‐E is out of cellular coverage; when the PinPoint‐E
is in coverage, data is sent to server as soon as possible.
This is the default for PinPoints with RAP version 1.3 or
lower.
• n=1 : Data sent only when polled. Data is stored until
polled using the Poll command sent by a server.