Sierra Wireless EV-DO - Manual (Page 133)

Configuration Commands
Rev 3.0B Feb.08 128
TCP
This group includes commands specific to TCP serial commu‐
nications.
Figure 1-7: AceManager : TCP
S0=n
This register determines how the PinPoint‐E responds to an
incoming TCP connection request. The PinPoint‐E remains in
AT Command mode until a connection request is received.
DTR must be asserted (S211=1 or &D0) and the PinPoint‐E
must be set for a successful TCP connection. The PinPoint‐E
will send a “RING” string to the host. A “CONNECT” sent to
the host indicates acknowledgement of the connection request
and the TCP session is established.
• n=0 : Off (Default).
• n=1 : On.
• n=2 : Use Telnet server mode on TCP connections.
• n=3 : With a Telnet connection, overrides the clientʹs
default echo, allowing the server on the host port to
perform the echo. CRLF sequences from the telnet client
will also be edited to simply pass CRs to the server on the
host port.
S7=n
Specifies the number of seconds to wait for a TCP connection
to be established when dialing out.
• n=seconds
S60=n
Telnet Client Echo Mode.
• n=0 : No Echo
• n=1 : Local Echo (Default)
• n=2 : Remote Echo