Sierra Wireless EV-DO - Manual (Page 159)

Configuration Commands
Rev 3.0B Feb.08 154
*PPTSV=n
Timer for Stationary Vehicles. Time interval in minutes that the
PinPoint‐E will send in reports when it is stationary.
• n=0 : Disabled
• n=1‐255 minutes
For example, if *PPTIME=10, the PinPoint‐E will send in
reports at least every 10 seconds while it is moving; however,
once it stops moving, it will slow the reports down to this
*PPTSV value.
Note: In order for the PPTSV (Stationary Vehicle timer) to take effect,
the PPTIME value must be set to a value greater than 0 and less than
the PPTSV value. The PPTSV timer checks for vehicle movement at
the PPTIME interval, so if PPTIME is disabled, then PPTSV will also
be disabled.
*UDPRGPS=n
Set or query GPS stamping of UDP Reliable packets. When set,
data received on the host serial port will be encapsulated with
the GPS date and time.
• n=0 : Disabled (default)
• n=1 : Enabled
1x/EV-DO
This group includes commands specific to 1x and EV‐DO. If
you are not connecting to a modem which uses EV‐DO or 1x,
you will not see this group in the menu.
Figure 1-19: AceManager : 1x/EV-DO