Sierra Wireless EV-DO - Manual (Page 34)

PinPoint-E EV-DO
29 20070914
Green checks in the boxes indicate the tests were successful
and your PinPoint‐E is functioning properly. At this point your
modem is configured and activated to work on the Verizon
network.
Note: These tests, depending on the strength of your signal, may take
a few minutes. Initially, while the tests are being performed, there may
be red
X s in the boxes. The Status line will give an indication of the
progress of the connection process.
If Test Modem Settings shows the status of your modem is
“Data Connection Failed ‐ Waiting for Retry”, “No Service”,
“No Carrier”, “Network Negotiation Failed”, “Network
Authentication Failed”, “Modem Not Registered”, or the Reg
Net light on the modem is not lit, double‐check your device
activation information and return to the Activate Modem step
to reconfigure your PinPoint‐E.
7. Setup Private Networking (C3x10)
Private Networking Data Link is a special account configu‐
ration that provides a more secure connection for your
PinPoint‐E and often provides a static IP with authentication
on an exclusive server. Consult your Verizon representative for
details about Private Networking Data Link if it’s something
you need for your account.
Before you start the configuration for Private Networking,
Data Link, the connection to the network may be checked.
Caution: Ensure the PinPoint-E has been activated before you
proceed with the Private Networking Data Link steps. Configuring
Private Networking Data Link before the PinPoint-E has been
activated can prevent successful activation.
• The Primary Home Agent (Primary HA) and Secondary
Home Agent (Secondary HA) are the network servers
responsible for IP addressing and routing. Fill in the infor‐
mation, as applicable.