Rtsi=n, Ig=n #u *pgps=n *ppcom1000=n *ppdevid=n *ppdist=n – Sierra Wireless EV-DO User Manual
Page 154

PinPoint-E EV-DO
149
20070914
•
n=1 : ATGPS1 will cause these strings to be sent out the
serial link once per second continuously until ATGPS or
until reset.
RTSI=n
Enable monitoring the RTS signal as in input event.
•
n=0 : Disable RTS input monitoring.
•
n=1 : Enable RTS input monitoring.
Caution: If RTS is used as an input, hardware flow control cannot be
enabled.
#IG=n
Time in seconds to wait for GPS acquisition before trans‐
mitting at high rates.
•
n=seconds
#U
Immediately issue GPS report to the ATS server IP and port.
Not available in AceManager.
*PGPS=n
Send NMEA GPS strings out serial link. Similar to ATGPS
except that the *PGPS value can be saved to NVRAM so that it
will continue to operate after resets.
•
n=0 : Disabled
•
n=1 : Send NMEA GPS strings out serial link.
*PPCOM1000=n
Enables support for extra inputs from a COM1000.
•
n=0 : Disable
•
n=1 : Enable
*PPDEVID=n
Whether or not the PinPoint‐E should include the 64‐bit device
ID in its GPS reports. *PPDEVID MUST be 1 if the modem uses
a Dynamic IP.
•
n=0 : Disable ID.
•
n=1 : Enable/display ID.
*PPDIST=n
GPS Report Distance Interval in 100 Meter Units (kilometer). 1
mile is approximately 1600 kilometers.