IBM RS/6000 - Manual (Page 164)

Table 26. SCSI-2 Fast/Wide Single-Ended Adapter-to-First Device Cables
M/T F/C Part
Number Length
(meters) Cable Description
Host
System 2111 06H6037 1.0 Adapter-to-first device (where first
device has two connectors), 8-bit
narrow bus
Host
System 2113 52G0174 1.5 Adapter-to-first device (where first
device has one connector),8-bit
narrow bus
Host
System 2115 06H6036 1.0 Adapter-to-first device (where first
device has two connectors),
16-bits wide bus
Host
System 2117 52G0173 0.94 16-bit Y-cable
Note:
1. When cables are ordered by feature code, the appropriate terminator is included with
the order. When cables are ordered by part number, only the cable is included. For
terminator part numbers, refer to Table 28 on page 141.
2. For this adapter, the same cable can be used for either single-ended or differential
attachments. The difference in Feature Code orders is the terminator type. Refer to
Table 29 on page 142.
3. The external connector on this adapter is the SCSI-3 standard, 68-pin "P" cable
connector. Many of the 18-bit SCSI devices also use this connector type, and as a
result some cables can be used as either adapter-to-first device or device-to-device
cables, depending upon what type of SCSI connectors are present on the devices.
140 Introduction to PCI-Based RS/6000 Servers