IBM RS/6000 - Manual (Page 151)

This command generates a list of adapters using bus I/O that looks similar to
the following:
O fda bus_io_addr x 3f - x 3f5
O fda bus_io_addr2 x 3f7
O ppa bus_io_addr x 3bc - x 3be
O sa bus_io_addr x 3f8 - x 3ff
O sa1 bus_io_addr x 2f8 - x 2ff
O sioka bus_io_addr 1 x 6
O sioma bus_io_addr 1 x 6
O ampx bus_io_addr x 2a - x 2a6
O sa2 bus_io_addr x 1 4 - x 1 7
ent bus_io_addr x 3 - x 31f
O scsi bus_io_addr x f - x f ff
O scsi1 bus_io_addr x 1 - x 1 ff
5. Select a Bus I/O Address that is not currently in use.
6. If any ISA adapter is installed, check for available Bus Memory values by
entering the following command:
lsresource -l bus -a | grep bus_mem
This command generates a list of adapters using different Bus Memory
Addresses that looks similar to the following:
B ampx bus_mem_addr x e - x e1fff
B apm bus_mem_addr x e2 - x e3fff
B ent bus_mem_addr x c - x c3fff
B gga bus_mem_start x 1 - x 1ffffff
7. Select a Bus Memory that is not currently in use.
The valid Bus Memory values for use with the ISA Ethernet Adapter start at
0xc0000 and increment by 0x04000. For example, they are 0xc4000, 0xc8000,
and so on. The previous example shows
ent is using the first Bus Memory
range of 0Xc0000.
8. Install the ISA Ethernet Adapter device driver and diagnostic by choosing:
smit isa
Install ISA Adapter Software
to install the fileset device.isa.ethernet
9. After installing the software, you might enter:
smit isa
Add an ISA Adapter
10. Select ethernet isa IBM Ethernet ISA Adapter from the SMIT pop-up menu.
11. Select bus1 Available ISA Bus from the following SMIT pop-up menu.
12. From the menu described in Figure 40 on page 128, select the correct
Interrupt Level, Bus I/O Address, Bus Memory and Media Type values, and
press Enter.
Chapter 6. Adapter and Device Configuration on PCI-Based RS/6000 Servers 127