Gateway ALR 7200 - Manual (Page 106)

94 Maintaining and Troubleshooting the Gateway ALR 7200 Server
System problems
The system will not start up.
The keyboard doesn’t work.
Probable Cause Solution
The system is not
connected to an AC
outlet. Check the power cable(s) and make certain it
is connected to an AC power source.
Voltage selection
switch not set correctly. Make certain the voltage selection switch
reflects the correct power source.
One power supply is
not supplying power to
the load share module. Verify both power cords are plugged into
working AC outlets. Verify both power cords
are fully plugged into their AC-IN connectors
on rear of computer. Verify both power
supplies are set to the correct voltage range
(115-V AC or 230-V AC). Verify both power
supplies are turned on. Replace defective
power supply.
Probable Cause Solution
A key was depressed
while the system was
starting up. Clear the sticking key, then turn off the system,
wait for a few seconds, and then turn the
system back on.
The keyboard is not
plugged in or
connected properly. Check the cable. Make certain it is plugged in
correctly.
Something spilled into
the keyboard. Turn off the system. Turn the keyboard upside
down to let it dry before turning the system
back on.
The keyboard is
defective. Try a keyboard you know is working.
4077.boo Page 94 Thursday, January 21, 1999 9:48 AM