Pyromation Series 610 1_16 DIN - Manual (Page 82)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Upper
Display
Lower
Display
When Visible Description
SP Value -)
Display strategy 1, 3,
4, 5 and 6 if Digital
Input is not
=-7 in
config mode and
RSP is not used.
Target value of Setpoint.
Adjustable except in Strategy 6
SP1 Value -)
or
:-)
Display strategies 1
to 6, if Digital Input is
set for dual SP
(
=-7 in config
mode).
Target value of Setpoint 1. :-) means
SP1 is selected as the active Setpoint.
Adjustable except in Strategy 6
SP2 Value -)
or
:-)
Display strategies 1
to 6, if Digital Input is
set for dual SP
(
=-7 in config
mode).
Target value of Setpoint 2.
:-)
means
SP2 is selected as the active Setpoint.
Adjustable except in Strategy 6
Local Setpoint
Value '-)
:'-)
or
* '-)
If Remote Setpoint
Input is fitted and
Digital Input is not
=-7 in config
mode
Target value of Local Setpoint. :'-)
means the local setpoint is selected as the
active SP (if the digital input has been
overridden, the
_* character is lit instead).
Adjustable except in Strategy 6
Remote
Setpoint
Value
+-)
:+-)
or
* +-)
Target value of Remote Setpoint.
:+-)
means the remote setpoint is selected as
the active SP (if the digital input has been
overridden, the
_* character is lit instead).
Read only
Valve Position
Value )xxx
Display strategy 7 if
position indication
enabled () or
) = )C) The valve position as read by the Auxiliary
Input. Position is expressed as a
percentage from
) (fully closed) to
) (fully opened).
__ '-)
+-)
or
=# -)-
If Remote Setpoint
Input is fitted, Digital
Input is not
=-7
in
config mode and
-- C is enabled in
Setup mode
Setpoint Select. Selects between Local or
Remote Setpoints.
'-)
= local SP,
+-)
= remote SP,
=#
= selection via digital input (if configured).
Note:
'-)
or
+-)
will override the digital
input (active SP indication changes to * )
Adjustable except in Strategy 6
Actual SP
Value
-)+)
If a Ramping
Setpoint is in use
(
+) not Blank).
Actual value of selected Setpoint (e.g.
ramping SP value). Read only
SP Ramp
Rate Value
+) If
-@+
(ramping SP)
is enabled in Setup
mode.
Setpoint ramping rate, in units per hour.
Set to Blank (higher than ) to turn off
ramping. Adjustable except in Strategy 6
If
is fitted and
Digital Input is not
=-7
in config
mode
Remote Setpoint
Input
59305, Issue 6 – March 2006
P6170, P8170 & P4170 Model Group Page 77