Pyromation Series 610 1_16 DIN - Manual (Page 117)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
1 /
8
Din Indicator Units Display
The P8010 1 /
88
°°
11
16 16
Alarm Indications Alarm Indications
Press either or to reset the latched relay(s). Press either or to reset the latched relay(s).
Note: Note:
Press to select the parameter to be reset. Press to select the parameter to be reset.
Din indicators have an additional Units Display. In Operator Mode, this display
shows 3 or " when a temperature input range is displayed, and is blank for linear inputs.
The units display is also used in other modes as a confirmation of the parameter type
currently shown in the main display. This display is not fitted on P6010 / Din indicators.
The alarm status screen indicates any active alarms, in addition the associated
Alarm LED flashes.
For latching alarm outputs, the LED FLASHES when the alarm condition exists,
and goes to ON when the alarm condition is no longer present if the output has not
yet been reset, to indicate that the relay is in the Latched on condition.
Resetting Latched Alarm Outputs
Latched outputs can be reset whilst the Process variable or Alarm Status screens are
displayed, via the Digital Input (if fitted), with a communications command via the RS485
module (if fitted) or from the front keypad as follows:
Outputs will only reset if their alarm condition is no longer present.
CAUTION:
A reset will affect ALL latched outputs.
Resetting Alarm 1 Active Time, Minimum PV or Maximum PV
Press either or for three seconds.
The display briefly shows when the value is reset before the unit reverts to the
requested display.
°°
Page 112
P6010 & P8010 Model Group 59305, Issue 6 – March 2006
The stored Maximum PV value, Minimum PV value or Alarm 1 active Elapsed Time value can
be
reset via the Digital Input (if fitted), with a communications command via the
RS485 module (if fitted) or from the front keypad as follows:
The stored Maximum PV value, Minimum PV value or Alarm 1 active Elapsed Time value can
be
reset via the Digital Input (if fitted), with a communications command via the
RS485 module (if fitted) or from the front keypad as follows:
1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Page 112
P6010 & P8010 Model Group 59305, Issue 6 – March 2006
1 /
8
Din Indicator Units Display
The P8010 1 / Din indicators have an additional Units Display. In Operator Mode, this display
shows 3 or " when a temperature input range is displayed, and is blank for linear inputs.
The units display is also used in other modes as a confirmation of the parameter type
currently shown in the main display. This display is not fitted on P6010 / Din indicators.
The alarm status screen indicates any active alarms, in addition the associated
Alarm LED flashes.
For latching alarm outputs, the LED FLASHES when the alarm condition exists,
and goes to ON when the alarm condition is no longer present if the output has not
yet been reset, to indicate that the relay is in the Latched on condition.
Resetting Latched Alarm Outputs
Latched outputs can be reset whilst the Process variable or Alarm Status screens are
displayed, via the Digital Input (if fitted), with a communications command via the RS485
module (if fitted) or from the front keypad as follows:
Outputs will only reset if their alarm condition is no longer present.
CAUTION:
A reset will affect ALL latched outputs.
Resetting Alarm 1 Active Time, Minimum PV or Maximum PV
Press either or for three seconds.
The display briefly shows when the value is reset before the unit reverts to the
requested display.