Pyromation Series 610 1_16 DIN - Manual (Page 80)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Parameter Lower
Display
Upper Display
Adjustment Range
Default
Value
When
Visible
Deviation Alarm 2
Value =' ±span from setpoint '
=
=
Band Alarm 2 value* ' 1 LSD to full span from
setpoint. ' = C=
Alarm 2 Hysteresis* $4 Up to 100% of span Always
Auto Pre-tune enable /
disable ). =- disabled or
C
enabled
=- Always
Manual Control select
enable / disable ) C =- disabled or
C
enabled
=- Always
Setpoint Select shown
in Operator Mode,
enable / disable -- C =- disabled or
C
enabled
=- Slot A or B
configured for
Remote Setpoint
Setpoint ramp shown in
operator mode, enable /
disable -@+ =- disabled or
C
enabled
=- Always
SP Ramp Rate Value
+) 1 to 9999 units/hour or Off
(blank) Blank Always
Setpoint Value
-) Within scale range upper
and lower limits Range
minimum Always
Local Setpoint Value '-)
:'-)
or
* '-)
Within scale range upper
and lower limits.
: or
* before the legend
indicates if this is the
currently active SP
Range
minimum. @C  or
@C = +-)
Setpoint 1 Value -)
:-)
or
* -)
Within scale range upper
and lower limits.
: or
* before the legend
indicates if this is the
currently active SP
Range
minimum.
=# or
=#
=
=-
Setpoint2 Value -)
:-)
or
* -)
Within scale range upper
and lower limits.
: or
* before the legend
indicates if this is the
currently active SP
Range
minimum.
=# or
=# = =-
Set-up Lock Code
-' N
0 to 9999 Always
**First Operator mode displays follows.
Note:
Alarm parameters marked * are repeated in Configuration Mode.
Note:
**Once the complete list of Set Up Mode parameters has been displayed, the first
Operator Mode display is shown without exiting from Set Up Mode. Display seen is
dependant on the Display Strategy and status of Auto/Manual mode selection.
59305, Issue 6 – March 2006
P6170, P8170 & P4170 Model Group Page 75