Pyromation Series 610 1_16 DIN - Manual (Page 60)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Table 13. P6100, P8100 & P4100 Operator Mode Displays
Upper
Display
Lower
Display
When Visible Description
PV Value Active SP
Value
Display strategy 1
and 2.
(Initial Screen) Process Variable and target value of
currently selected Setpoint.
Local SP is adjustable in Strategy 2
PV Value Actual SP
Value
Display strategy 3
and 6
(Initial Screen) Process Variable and actual value of
selected Setpoint (e.g. ramping SP value).
Read only
PV Value Blank Display strategy 4.
(Initial Screen) Shows Process Variable.
Read only
Actual SP
Value Blank Display strategy 5.
(Initial Screen) Shows target value of currently selected
Setpoint. Read only
SP Value -)
Display strategy 1, 3,
4, 5 and 6 if Digital
Input is not
=-7 in
config mode and
RSP is not fitted
Target value of Setpoint.
Adjustable except in Strategy 6
SP1 Value -)
or
:-)
If Digital Input is set
for dual SP (
=-7 in
config mode).
Target value of Setpoint 1. :-) means
SP1 is selected as the active Setpoint.
Adjustable except in Strategy 6
SP2 Value -)
or
:-)
If Digital Input is set
for dual SP (
=-7 in
config mode).
Target value of Setpoint 2. :-) means
SP2 is selected as the active Setpoint.
Adjustable except in Strategy 6
Local Setpoint
Value '-)
:'-)
or
* '-)
If Remote Setpoint
Input is fitted and
Digital Input is not
=-7 in config
mode
Target value of Local Setpoint. :'-)
means the local setpoint is selected as the
active SP (if the digital input has been
overridden, the
_* character is lit instead).
Adjustable except in Strategy 6
Remote
Setpoint
Value +-)
:+-)
or
* +-)
If Remote Setpoint
Input is fitted and
Digital Input is not
=-7
in config
mode
Target value of Remote Setpoint. :+-)
means the remote setpoint is selected as
the active SP (if the digital input has been
overridden, the
_* character is lit instead).
Read only
__ '-)
+-)
or
=# -)-
If Remote Setpoint
Input is fitted, Digital
Input is not
=-7 in
config mode and
-- C is enabled in
Setup mode
Setpoint Select. Selects between Local or
Remote Setpoints.
'-)
= local SP,
+-)
= remote SP,
=#
= selection via digital input (if configured).
Note:
'-) or +-) will override the digital
input (active SP indication changes to * )
Adjustable except in Strategy 6
Actual SP
Value
-)+)
If a Ramping
Setpoint is in use
(
+) not Blank).
Actual value of selected Setpoint (e.g.
ramping SP value). Read only
SP Ramp
Rate Value
+) If -@+ (ramping SP)
is enabled in Setup
mode.
Setpoint ramping rate, in units per hour.
Set to Blank (higher than ) to turn off
ramping. Adjustable except in Strategy 6
59305, Issue 6 – March 2006
P6100, P6120, P8100 & P4100 Model Group Page 55