IDEC MicroSmart Pentra - Manual (Page 85)

C ONFIGURING PID M ODULE USING W IND LDR
6-20 FC5A MicroSmart PID Module User’s Manual FC9Y-B1283
Offset from
the control
register
Parameter Description R/W
CH0 CH1
(7) +186 +396 ARW (Anti-Reset Windup) 0 to 100% R/W
(8) +187 +397
Output Manipulated
Variable Rate-of-Change
0 to 100%/sec R/W
(9) +188 +398 Alarm 1 Value
Refer to the valid range for alarm 1 to alarm 8 values
shown in the following table.
R/W
(10) +189 +399 Alarm 2 Value
(11) +190 +400 Alarm 3 Value
(12) +191 +401 Alarm 4 Value
(13) +192 +402 Alarm 5 Value
(14) +193 +403 Alarm 6 Value
(15) +194 +404 Alarm 7 Value
(16) +195 +405 Alarm 8 Value
(17) +197 +407
Output Manipulated
Variable Upper Limit
When output type is voltage:
Output manipulated variable lower limit to 100%
When output type is current:
Output manipulated variable lower limit to 105%
R/W
(18) +198 +408
Output Manipulated
Variable Lower Limit
When output type is voltage:
0% to output manipulated variable upper limit
When output type is current:
-5% to output manipulated variable upper limit
R/W
(19) +199 –
Cooling Proportional
Band
0.0 to 10.0 times
(Cooling proportional band is the multiplication of
heating proportional band)
R/W
(20) +200 – Overlap/Dead Band
When input range unit is Celsius:
-200.0 to 200.0°C
When input range unit is Fahrenheit:
-200.0 to 200.0°F
When input is voltage or current:
-2000 to 2000
R/W
Valid Range for Alarm 1 to Alarm 8 Value
*1: When input is voltage/current, full scale is the linear conversion span.
*2: When input is voltage/current, the valid range is the linear conversion minimum value to linear conversion maximum
value.
Alarm Type Valid Range
Upper Limit Alarm –(Full scale) to full scale *1
Lower Limit Alarm –(Full scale) to full scale *1
Upper/Lower Limits Alarm 0 to full scale *1
Upper/Lower Limit Range Alarm 0 to full scale *1
Process High Alarm Input range lower limit to input range upper limit *2
Process Low Alarm Input range lower limit to input range upper limit *2
Upper Limit Alarm with Standby –(Full scale) to full scale *1
Lower Limit Alarm with Standby –(Full scale) to full scale *1
Upper/Lower Limits Alarm with Standby 0 to full scale *1