IDEC MicroSmart Pentra - Manual (Page 66)

C ONFIGURING PID M ODULE USING W IND LDR
F C5A MicroSmart PID Module User’s Manual FC9Y-B1283 6-1
6: C
ONFIGURING
PID M
ODULE
U
SING
W
IND
LDR
This chapter describes configuration procedure of the PID modules using WindLDR, PID module configuration
dialogs, and monitoring.
Procedure to configure the PID module
1. Expansion Modules Configuration Dialog Box
To open the Expansion Modules Configuration dialog box, follow one of the procedures below.
Procedure 1:
1. From the WindLDR menu bar, select View > Project Window to open the Project Window.
2. Double-click on Expansion Modules Configuration in the Project Window.
Procedure 2:
1. From the WindLDR menu bar, select Configuration > Expansion Modules.
Expansion Modules Configuration Dialog Box
After specifying the quantity of modules and selecting the slot number to which the PID module is connected,
designate the module type number, control register (data register) and control relay (internal relay). After
designating those parameters, click on Configure Parameters button to open the PID Module
Configuration dialog.
2. PID Module Configuration Dialog Box
All parameters for the PID module can be configured in this dialog box. Configure the desired
parameters and click on OK button to close the dialog.