HP XU - Manual (Page 62)

2 How to Install Accessories Inside Your PC Workstation
Installing Mass Storage Devices
46 English
12 Replace the HP UltraFlow airflow guide and reconnect the fan to the
system board (see the illustration on page 29).
13 Install any other accessories before replacing the cover and
completing the installation.
14 Follow the instructions below to complete the installation.
Completing the Installation of a Hard Disk Drive
When a SCSI Hard Disk
Drive Is Installed 1 Switch on the computer.
2 To ensure compatibility, use the FDISK utility to delete any
partitions on the new hard disk.
3 Re-boot the computer.
Refer to the operating system documentation for information on
formatting a drive.
When an IDE Drive
Is Installed 1 Switch on the computer.
2 To display the device in POST, press while the PC Workstation
re-starts.
3 If an error message appears, follow the instructions provided by the
Error Message Utility. When prompted, press to run the Setup
program.
4 Select the Advanced menu, and the IDE Devices submenu. In the
Primary Master item, check that the details for the device have been
correctly detected by the Setup program.
5 Press to save and exit Setup.
Refer to the operating system documentation for information on
formatting a drive.
NOTE
If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
to confirm that you want
to remove the device. The system configuration will be updated
automatically.
crystal.bk : cryst-2.fb4 Page 46 Monday, March 23, 1998 4:09 AM