HP XU - Manual (Page 50)

2 How to Install Accessories Inside Your PC Workstation
Installing Memory
34 English
Installing More Memory on the Video Adapter
For XU Models Your PC Workstation is equipped with a video adapter that supports 2D
and 3D graphics. If you need to have more video memory to display
more colors, higher resolutions, or for increased speed, you can install
more video memory on the video adapter.
To find out about available video memory upgrades, refer to the HP
World Wide Web Site at
http://www.hp.com/go/kayaksupport/
Refer to page 90 for information on video resolutions.
CAUTION
Static electricity can damage electronic components. Turn off
all equipment. Do not let your clothes touch the accessory.
Handle the accessory as little as possible and with care.
To install a video memory module:
1 Switch off the display and computer, and disconnect the power
supply cables and any telecommunications cables. Remove the
computer’s cover (see page 25) and carefully place the
PC Workstation on its side.
2 Carefully remove the board from the accessory slot, holding the
board at each end by its top edge. Do not bend the board. With its
components facing up, place the board on a clean, flat, solid, static-
free surface. Handle the board by its edges.
3 Attach the memory module to the connectors on the video adapter.
(The different accessory
slots are identified in the
illustration on page 96.)
crystal.bk : cryst-2.fb4 Page 34 Monday, March 23, 1998 4:09 AM