Configuring a scsi accessory – HP XU User Manual
Page 121
English
105
4 Technical Information
Configuring a SCSI Accessory
Configuring a SCSI Accessory
There are two ways to configure a SCSI accessory:
•
SCSISelect — for use with Internal Wide 16-bit SCSI devices
& HP FastRAID (Adaptec).
•
SCSI Configuration Utility — for use with External and Internal
16/8-bit SCSI devices (Symbios).
NOTE
You cannot boot from a device connected to the Symbios controller
when HP FastRAID is installed.
To disable a boot device:
1 Go to the
Advanced
menu in the Setup program.
2 Select the SCSI channel you wish to set.
3 Enable or disable the
Option ROM Scan
as required.
Using SCSI Select
ATTENTION
The SCSISelect
™
utility is intended for advanced users only.
Note that the SCSISelect options displayed on your screen may
be different from those described here. Some options are not
displayed if the HP FastRAID option is installed.
The SCSISelect utility is accessed by pressing
during the
computer’s start-up process when the message
Press
for
SCSISelect(TM) Utility!
is displayed.
crystal.bk : cryst-4.fb4 Page 105 Monday, March 23, 1998 4:09 AM