HP XU - Manual (Page 40)

2 How to Install Accessories Inside Your PC Workstation
Supported HP Accessories
24 English
Supported HP Accessories
This chapter describes how to install memory, mass storage devices,
and accessory boards in your computer.
Contact your dealer for an up-to-date list of supported devices.
NOTE
256 MB registered ECC SDRAM DIMMs cannot be used with non-
buffered 32 MB, 64 MB or 128 MB DIMMs.
Up to six accessory boards
can be installed:
- One AGP slot (graphics)
- Three 32-bit PCI slots (one used by SCSI/LAN board, one with RAID
port)
- One combination PCI or ISA slot
- One 16-bit ISA slot
Front Access Drives, for example:
- 3.5-inch 1.44 MB flexible disk drive
(one third height)
- 5.25-inch 1.2 MB flexible disk drive
(half height)
- 5.25-inch tape drive (half height)
Internal Mass
Storage Devices
5 Pairs of Rails for Front
Access Devices:
- 3.5-inch disk drive rails
- 5.25-inch disk drive rails
Main Memory Upgrades
(DIMM slots for ECC SDRAM):
- 32 MB (Non-buffered)
- 64 MB (Non-buffered)
- 128 MB (Non-buffered)
- 256 MB (Registered - see note below)
crystal.bk : cryst-2.fb4 Page 24 Monday, March 23, 1998 4:09 AM