HP XU - Manual (Page 150)

4 Technical Information
Using the ArrayConfig Program
134 English
Resolving Problems
If you experience problems using the HP FastRAID option, check that:
1 The ARO-1130 adapter BIOS sign-on message appear
during bootup? If not, check that the ARO-1130 adapter is properly
seated in the RAIDport slot.
2 All SCSI bus cables and power cables are connected.
If you are having trouble booting from the FastRAID array:
1 Check the settings in the HP Setup program that the Array1000
Family Raid Adapter is selected in position one. To do this:
a From the HP Setup program, select the Boot menu group, then
the Hard Disk Drive item. If the Array1000 Family Raid Adapter
is already in position one, then no changes are necessary.
Otherwise, select the Array1000 Family Raid Adapter by using
the up and down arrows, then press the
key to move it up
the list. Save your changes before you exit the Setup program.
2 Check that the array has been selected as the boot device using the
ArrayConfig utility:
a Insert the ArrayConfig utility disk in drive A.
b Reboot your computer and when the ArrayConfig Main menu
appears, select Display Boot Order. If the array is at the top of the
list, preceded by the words Unit 0, no changes are necessary.
Otherwise, highlight the array name and press
, then use
the arrow keys to move it to the top of the list.
c Exit the ArrayConfig utility and reboot your computer.
3 Check the HP Setup settings to make sure that each drive has a
unique SCSI ID.
crystal.bk : cryst-4.fb4 Page 134 Monday, March 23, 1998 4:09 AM