HP XU - Manual (Page 117)

English 101
4 Technical Information
The HP Summary Screen and Setup Program
The HP Summary Screen and Setup Program
This section introduces the HP Summary Screen and the HP Setup
program. You can use the Summary Screen and the Setup program to
configure your PC Workstation and solve configuration problems with
your PC Workstation.
Viewing the HP Summary Screen
Check your PC Workstation’s configuration when you first use the PC
Workstation and each time after you install, remove, or upgrade
accessories. To check the configuration:
1 Turn on the display and then the PC Workstation. If the PC
Workstation is already turned on, save your data and exit all
programs, then restart the PC Workstation. Consult your operating
system documentation for any special instructions concerning
turning off and then restarting your PC Workstation.
2 While the start-up logo appears on your display, press . This
takes you to the HP Summary Screen. (To go immediately into the
Setup program, and bypass the Summary Screen, press
instead
of ). The Summary Screen is displayed for only a short time. To
retain the screen (until you decide to leave it), press .
Starting the HP Setup Program
1 Turn on the display and then the computer. If the PC Workstation is
already turned on, save your data and exit all programs, then restart
the PC Workstation. Consult your operating system documentation
for any special instructions concerning turning off and then
restarting your PC Workstation.
2 Press while Setup is displayed at the bottom of the screen.
If you fail to press in time and the start-up process continues,
you will need to restart your PC Workstation to go through the POST
again so you can press
.
3 The opening screen of the PC Workstation’s Setup program is
displayed, similar to the one on the next page. Note that the Main
menu selection is highlighted.
crystal.bk : cryst-4.fb4 Page 101 Monday, March 23, 1998 4:09 AM