HP XU - Manual (Page 130)

4 Technical Information
Configuring a SCSI Accessory
114 English
Starting the SCSI Configuration Utility
You access the SCSI Configuration Utility by pressing when the
message Press F6 to start Configuration Utility... is
displayed during the PC Workstation’s start-up routine. A further
message is then displayed:
Please wait, invoking Configuration
Utility... before the Main menu of the Symbios Logic SCSI
Configuration utility appears.
Main Menu
NOTE
The items shown on your screen may be different from those shown
below.
Use the and keys and the key to make a selection
from this menu.
You can only select an adapter if the current status is “On”. Changes
are possible only if NVRAM (non-volatile memory on your adapter) is
present.
Symbios Logic SCSI Configuration Utility
Version 1.07
MAIN MENU
Port Irq ------Status------ NvRAM
Num Level
Current Next-Boot Found
.SYM53C875 E800 3 On On Yes
Change Adapter Status.
Adapter Boot Order 1 .
Additional Adapter Configuration
1
.
Display Mode = Verbose.
Mono/Color.
Language
2 .
Help.
Quit.
Use arrow keys to select from menu. Then press ENTER
BIOS Code Segment: C800
1. Only used if more than one Symbios card is installed.
2.
Not available (English only).
crystal.bk : cryst-4.fb4 Page 114 Monday, March 23, 1998 4:09 AM