PLANET DSP-1000 - Manual (Page 40)

- 40 -
Wait a few seconds and turn it back on.
7. Go back to the Network category in the setup menu and check
that the unit has properly acquired its IP address.
If it does not work, try some of the following tips:
• Reboot the unit by turning off the power switch and try again.
• Turn off the WEP encryption and try it again without.
• Set the IP and DNS address manually.
• Move the unit as close as possible to the wireless access point.
• Login to the wireless access point and turn off any speed or
performance enhancements for the wireless connection. Use only
the most basic features.
• Talk to your system administrator to make sure the wireless
connection is not restricted to certain computers only and the
Dsp-1000 can access it.
• Make sure that the wireless kit works and has been installed
properly.
• Test the unit in a different environment.
3.10 Time & Date
To set date and time on the DSP-1000, the unit requires an internet
connection to synchronise the time with an NTP server. Without real time
clock (RTC) and battery, the time and date will be reset at reboot or power
loss.