PLANET DSP-1000 - Manual (Page 104)

- 104 -
4 Scrolling Off Turns the scrolling text message OFF.
5 Volume Changes the volume level.
6 Mute Mutes the audio output.
- System Command
1 Reboot Reboots the device.
2 Refresh Content
Refreshes and updates current playlist and
content.
3 Play List by Single Sets playlist to Single mode.
4 Play List by Date Sets playlist to Date mode.
5 Play List by Time Sets playlist to Time mode.
6
Play List by
Date/Time
Sets playlist to Date/Time mode.
7 Repeat Mode Turns on the Repeat mode.
8 Stop Auto Play Stops playback.
NOTE:
When changing the settings via remote commands, the GUI
will only be updated after a reboot. E.g.: After sending the
command to set the playlist to Date mode, the GUI will still
show the previous playlist mode until the device has been
rebooted.
A.3 Message Control
Start the configuration tool and select the Message Control tab. Right
click in the field on the left hand side to add the IP address of your
DSP-1000. Once listed, click on it to select the unit and then send the
message to update the scrolling text on the DSP-1000.