PLANET DSP-1000 - Manual (Page 26)

- 26 -
1
All File
Copy
Use this to easily and quickly copy new files to or from your
local drive. This will copy all files found in the root directory
of either your local drive or the remote location but does
not include any sub-folders. Existing files with the same
name will be overwritten. To copy only single files or
sub-folders, use the SELECT button on the remote control.
2
All File
Erase
This function can be used to erase all data on the local
drive or one of the attached USB drives. Works only with
FAT32 formatted drives!
3
Setup
Value
Use this function to reset all settings to their factory default
value. We recommend resetting it after every firmware
upgrade.
4 Play Mode
Select your preferred play mode from 4 different types:
Standard - Default setting for standard media player with
user input via remote control.
Repeat - Automatically plays and repeats all files stored in
the root directory after boot up.
Manual - Plays title file at boot up as well as after user
input via numeric buttons 000-999.
Standby - Plays title file at boot up and then waits for
further user input (buttons 000-999).
5
Remote
Command
Path
Define the location that the DSP-1000 should monitor for
remote commands. Set it to HDD if you intend to use the
Configuration Tool or TFTP. PC1 and PC2 can only be
selected when the playlist mode is enabled and the playlist
path is set to PC1 or PC2.
6
Auto
ON/OFF
Turning this function ON, allows you to set a time for the
unit to automatically turn ON and also a time for it to turn
OFF again.
3.4 Misc3 Category
In this category, you can disable the onscreen messages (OSD) and
configure the options for the scrolling text message. Use the arrow keys
on your remote control for navigation and the ENTER button to configure
the settings.