PLANET DSP-1000 - Manual (Page 16)

- 16 -
Chapter 2
Hardware Installation
Physical Installation Requirement
For the download function and most of the play modes to work, an
internal drive has to be installed. The DSP-1000 just could install both
one device, and system just select among device for storage device:
• 2.5” SATA HDD (Hard Disk Drive)
• CF
card
NOTE:
The DSP-1000 only supports the FAT32 file system or for CF
cards also FAT16. Make sure your hard drive is formatted
using FAT32 before you install it. If formatted using NTFS, the
DSP-1000 will be able to read from the drive but will not be
able to write any data to it!
1. Prepare your HDD and format it using FAT32.
2. Install the drive or CF card and make sure all cables are
connected.
3. Switch the power on your DSP-1000 to ON, and wait for the
system to boot. This might take up to a minute.
4. If you already have some media files on the drive, you will now be
able to access them from the file library.
5. If the drive is still empty, use the File Copy command in the
Setup menu to copy new files from an external USB drive to the
2