PLANET DSP-1000 - Manual (Page 30)

- 30 -
4. Use TFTP to download the config.conf file to your computer:
tftp -i [IP address of your DSP-1000] GET /config.conf
C:\config.conf
To load the new settings, use the configuration tool or do the following:
1. Turn on your DSP-1000 and wait for it to boot.
2. Use TFTP to upload the config.conf file to your DSP-1000:
tftp -i [IP address of your DSP-1000] PUT C:\config.conf
/config.conf
3. Enter the Configuration Menu as described earlier.
4. Select RESTORE and press ENTER on your remote control to
load the settings.
5. The unit will automatically reboot after the new settings have
been uploaded.
NOTE:
If you do not have a local drive installed on the DSP-1000, the
config.conf file will be stored in the memory. If you turn off the
power using the hardware switch on the DSP-1000, this file
will be lost, so transfer or upload it BEFORE you turn off the
unit.