Solare Datensysteme Solar-Log - Manual (Page 94)

94
Configuring connected devices
18�4 Device Detection
During the Device Detection process, all of the predefined devices in the Device Definition menu which
are connected to the Solar-Log™ interfaces are searched for and recognized. During the Device Detection
process, the Solar-Log™'s internal data structure is prepared for these devices.
Procedure:
•
Select Configuration | Devices | Detection from the menu
•
The devices which were predefined in the Device Definition menu are displayed in the overview.
Fig.: Device detection - not started yet
•
START Device Detection
•
The Device Detection goes from the top listed interface to the bottom listed interface when
searching for devices.
The status of the Device Detection is displayed in the progress bar
Fig.: Progress of the Device Detection
•
The detected devices are displayed with the number of devices per bus .
•
If all of the devices on a bus have been detected, the rest of the search can be skipped. The search
is then continued on the next bus.
•
The Device Detection is completed once all of the buses have been checked.
Status message: New device detected, the data is being reformatted.
•
Restart the Solar-Log™