Solare Datensysteme Solar-Log - Manual (Page 120)

120
Editing Data
Resetting inverter configuration section
If the Device Detection needs to be started again, it is recommended to delete the previous inverter con-
figuration with this function.
Procedure
•
Click on RESET,
•
If you are sure that the inverter configuration should be deleted, click on Continue. Otherwise click
on Cancel.
•
The data and inverter configuration are deleted.
•
The Solar-Log™ reboots itself.
Restore factory settings
This function restores the Solar-Log™ to its factory settings. All of the yield data and configuration is de-
leted.
Procedure
•
Click on RESET,
•
If you are sure that the data should be deleted, click on Continue. Otherwise click on Cancel.
•
The factory settings are being restored
•
The Solar-Log™ reboots itself.
Note:
The network settings remain with the Solar-Log 1200 and 2000.
DHCP is enabled with the Solar-Log 300