Solare Datensysteme Solar-Log - Manual (Page 173)

173
Direct Device Configurations (Solar-Log 1000)
26�4 Initial configuration
The "Initial configuration" menu is opened automatically at the initial startup. However, it can be opened
again at any time afterwards by going to the Config. | Start | Initial Configuration menu.
The initial configuration is made through dialog boxes:
•
Time settings and IP address
•
Inverter selection
•
Power meter on S0 input
•
Performing inverter detection (Config. / Start / Inverter detection)
Procedure:
•
Select the Config. | Start | Initial Configuration menu.
•
The time setting and IP address are displayed in the dialog box.
26�4�1 Time settings and IP address
The clock time is factory-set, but it may be lost due to long periods of storage.
System settings
The time zone, date and summertime values must be set correctly, so that no incorrect statuses or results
are obtained during monitoring and graph display, e.g. when e-mail messages are sent or when a curve is
displayed on the day graph.

Network Settings section
IP Address
In general, the IP address only needs to be changed or checked if Solar Log 1000 is to be connected to a
router without the DHCP service, or connected directly to a PC.
The IP address is to DHCP by default. This can be changed here to a network address which is appropriate
for the local network.
After saving, the Solar-Log 1000.restarts automatically
Obtain IP address automatically
The IP address can be obtained automatically if the Solar-Log 1000 is connected to an Internet router with
the DHCP service enabled.
After saving and the automatic restart, the new IP address is displayed accordingly. The Solar-Log 1000
can now be reached at this address and it has automatic access to the Internet.
Procedure
•
Enter all the related data (see above list)
•
Touch Save and then Next to go to the next dialog.