Solare Datensysteme Solar-Log - Manual (Page 169)

169
Direct Device Configurations (Solar-Log 500)
25�5�7 Re-detecting inverters
If new inverters have been added to the system or replaced, it will also be necessary to carry out a new
detection. This will not cause any loss of data, as Solar Log 500automatically re-formats the data.
Note
Before preforming detection, it is important to save the current system data and make a
backup.
25�6 Internal Settings
25�6�1 Reset
There are three options in the Internal | Reset menu
•
Delete data
In certain circumstances after an inverter detection, it may occur that incorrect or unusable data
are displayed. In this case, the stored can be deleted without having to reconfigure the Solar Log
500 completely.
•
Delete inverter
If another inverter detection has to be started, it is possible to delete the inverter data only, with-
out having to delete the rest of the configuration.
•
Restore factory settings
This is used to reset the device to its factory settings. The network configuration remains unaf-
fected.
Procedure:
•
Go to the Internal | Reset menu.
•
Select Delete data, Delete inverter or Factory settings.
•
Select Yes .
•
Confirm by pressing ENTER