Solare Datensysteme Solar-Log - Manual (Page 88)

88
Configuring connected devices
18 Configuring connected devices
From the menu Configuration | Devices , the PV plant components connected to the Solar-Log™ can be
•
defined
•
detected
•
and configured.
We recommend the following procedures for new installations:
•
First define the interface to be used for the connected devices
•
Device detection
•
Device configuration
18�1 Device definition
The Configuration | Devices | Definition menu is divided into the following sub-sections:
•
Interfaces
•
Smart Home or Smart Energy
•
CT (only Solar-Log™ Meter)
•
Large external display (advanced settings have to be activated)
•
SCB (only Solar-Log 1000 and 2000)
18�1�1 Configuring the device interface
The interface for the connected devices needs to be defined from the Configuration | Devices | Definition
| Interfaces menu before performing a device detection.
S0-IN A
Here you can configure whether an S0 meter is connected to this input.
S0-IN B
Here you can configure whether an S0 meter is connected to this input.
RS485-A (only Solar-Log 1000, 1200 and 2000)
Here you can configure the components that are connected to this input. These components can be:
•
Inverter/Other
•
Power meters or
•
Sensors
If a wireless package is used in this bus, the wireless package button needs to be activated.