Settings for analog modem, Settings for gprs modem – Solare Datensysteme Solar-Log User Manual
Page 177

177
Direct Device Configurations (Solar-Log 1000)
Alternate DNS server
In some networks, the DNS server is a separate address for resolving Internet addresses, and is not the
same as the Internet router (gateway).
In this case, tick the check box and enter the IP address of the DNS server.
Settings for analog modem
If Internet access by analog modem has been selected, the access data of the telephone service provider
must be entered here.
Note
Since the cost of analog Internet access has risen drastically in recent years, we recom-
mend checking if it might be more cost effective to use a mobile service provider for the
data transmission.
Settings for GPRS modem
In many cases where no DSL or telephone connection is available, a mobile phone connection to the Inter-
net is the only option for sending e-mails, text messages (SMS) and data over the Internet to the home-
page.
All of the data for the German networks is pre-configured. These pre-configurations are available when
configuring via a web browser. When configuring via the display of the Solar-Log 1000, this data has be
entered manually.
Enter the following configuration information here; this information can be obtained from your mobile
service provider:
APN
APN (Access Point Name) of the mobile service provider
Users
User name for your mobile phone account
Password
Password for the mobile phone account
SIM PIN code
PIN number of the SIM card
Procedure
•
Enter
All of the Data
The mobile service provider recommends leaving the user name and password empty; however,
sometimes it is necessary to type in some text in order to establish the data connection success-
fully.
•
Touch
Save
and then Next to go to the next dialog.
•
Setting options and testing the GPRS modem connection