RIGOL DG1000Z Series - Manual (Page 65)

Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-15
Example: To Output Sine Waveform
This section mainly introduces how to output a sine waveform (Frequency: 20kHz,
Amplitude: 2.5Vpp, DC Offset: 500 mV
DC
, Start Phase: 90°) from the [CH1]
connector.
1. To select output channel
Press CH1|CH2 to select CH1. Now the border of the channel status bar is
displayed in yellow.
2. To select the Sine
Press Sine to select the sine waveform. The backlight goes on and the
corresponding menu is displayed in the right of the screen.
3. To set the frequency
Press Freq/Period to highlight “Freq”, and then use the numeric keyboard to
input 20. Then, select “kHz” from the pop-up menu.
4. To set the amplitude
Press Ampl/HiLevel to highlight “Ampl”, and use the numeric keyboard to
input 2.5. Then, select “Vpp” from the pop-up menu.
5. To set the offset
Press Offset/LoLevel to highlight “Offset”, and then use the numeric keyboard
to input 500. Then, select “mV
DC
” from the pop-up menu.
6. To set the start phase
Press Start Phase, and then use the numeric keyboard to input 90. Then,
select “°” from the pop-up menu. The start phase ranges from 0° to 360°.
7. To enable the output
Press Output1 to turn CH1 output on. At this point, the backlight goes on and
the [CH1] connector outputs the configured waveform.
8. To observe the output waveform
Connect the [CH1] connector of DG1000Z to the oscilloscope using BNC cable.
The waveform is as shown in the figure below.