RIGOL DG1000Z Series - Manual (Page 35)

Chapter 1 Quick Start RIGOL
DG1000Z User’s Guide 1-17
2. Current Function and Page Up/Down Indicator
Display the name of the function selected currently. For example, “Sine” is
displayed when the sine is selected and “Edit” is displayed when the arbitrary
waveform editing function is selected. Besides, the up and down arrows at the
right of the function name are used to indicate whether page up/down is
permitted now.
3. Menu
Display the operation menu of the function selected currently.
4. Status Bar
: displayed when the instrument is connected into LAN correctly.
: displayed when the instrument is in remote mode.
: displayed when the front panel of the instrument is locked.
: displayed when a USB storage device is detected.
: displayed when the instrument is connected with power amplifier correctly.
5. Waveform
Display the waveform currently selected in each channel.
6. Channel Status Bar
Used to indicate the selected status and on/off status of the channels. When
CH1 is selected, the border of the bar is displayed in yellow. When CH2 is
selected, the border of the bar is displayed in blue. When the output of CH1 is
enabled, the “CH1” in the bar is highlighted in yellow. When the output of CH2 is
enabled, the “CH2” in the bar is highlighted in blue.
Note: you can enable the outputs of the two channels but you cannot select the
two channels at the same time.
7. Frequency
Display the waveform frequency of the channel. Press Freq/Period to highlight
“Freq” and use the numeric keyboard or direction keys and knob to modify this
parameter.
8. Amplitude
Display the waveform amplitude of the channel. Press Ampl/HiLevel to
highlight “Ampl” and use the numeric keyboard or direction keys and knob to
modify this parameter.