RIGOL DG1000Z Series - Manual (Page 27)

Chapter 1 Quick Start RIGOL
DG1000Z User’s Guide 1-9
14. Function keys
Output multiple types of modulated waveforms.
—
Support multiple modulation types: AM, FM, PM, ASK, FSK,
PSK and PWM.
—
Support internal and external modulation sources.
— The backlight turns on when this function is selected.
Output sweep waveform for Sine, Square, Ramp and Arb
(except DC).
—
3 sweep types: Linear, Log and Step.
—
3 types of trigger sources: Internal, External and Manual.
— Provide frequency mark function used to control the status
of the sync signal.
— The backlight turns on when this function is selected.
Output Burst waveform for Sine, Square, Ramp, Pulse and Arb
(except DC).
—
3 burst types: NCycle, Infinite and Gated.
—
Noise can also be used to generate Gated Burst.
— 3 types of trigger sources: Internal, External and Manual.
— The backlight turns on when this function is selected.
Used to set the auxiliary function parameters and system
parameters. The backlight turns on when this function is
selected.
Store or recall the instrument state or the user-defined arbitrary
waveform data.
—
A nonvolatile memory (C disk) is built in and a USB storage
device (D disk) can be connected.
—
The backlight turns on when this function is selected.
To get the help information of any front panel key or menu
softkey, press this key and then press the desired key.
Note:
1) When the instrument is working in remote mode, press this
key to return to local mode.
2) Used to lock or unlock the keyboard. Press and hold Help
to lock the front panel keys and at this point, the front panel
keys (except Help) are not available. Press and hold this
key again to unlock.