RIGOL DG1000Z Series - Manual (Page 32)

RIGOL Chapter 1 Quick Start
1-14 DG1000Z User’s Guide
Power On and Inspection
To Connect to Power
Please connect the generator to AC power supply using the power cord supplied in
the accessories (as shown in the figure below). The AC power supply specification of
this generator is 100-240V, 45-440Hz. The maximum input power of the instrument
cannot exceed 30W. When the signal generator is connected to AC power supply via
this connector, the instrument adjusts itself to select the correct voltage range
automatically and users do not need to select the voltage range manually.
Figure 1-3 Connect to Power
CAUTION
To avoid electric shock, make sure that the instrument is correctly
grounded.
Power-on
After the power supply is correctly connected, press the power key
at the front
panel to turn on the generator. During the start-up, the instrument executes
initialization and self-test. After that, the default interface is displayed. If the
instrument does not start normally, please refer to the introduction in
“Troubleshooting”.