RIGOL DG1000Z Series - Manual (Page 64)

RIGOL Chapter 2 Front Panel Operations
2-14 DG1000Z User’s Guide
To Enable Output
After configuring the parameters of the waveform selected, waveform output could
be enabled.
Before enabling waveform output, you can also configure parameters (such as
Impedance and Polarity) related to the channel output through Channel Set menu
in Utility. For details, please refer to the introduction in “Output Set”.
Press Output1 at the front panel to turn CH1 output on. At this point, the backlight
of the button turns on and the [CH1] connector at the front panel outputs the
configured waveform.