RIGOL DG1000Z Series - Manual (Page 144)

RIGOL Chapter 2 Front Panel Operations
2-94 DG1000Z User’s Guide
Restore Default
Restore the instrument to its default state.
Press Utility  Set To Default  OK, the backlight of Utility turns off and switch
the instrument to Sine display mode. The default values are shown in the table below.
Note that the items marked with “*” are set at the factory and are related to the set
of the users and will not be affected by the Set To Default operation.
Table 2-4 Factory Default Values
Parameters Defaults
Channel Parameters
Current Carrier Waveform
Sine
Output Impedance HighZ
Output Load 50 Ω
Sync Output On
Sync Polarity Pos
Sync Delay 0s
Channel Output Normal
Output Mode Normal
Gated Polarity Pos
Range Auto
Waveform Sum Switch Off
Sum Source Sine
Sum Frequency 1kHz
Sum Ratio 100%
Basic Waveform
Frequency
1kHz
Amplitude 5Vpp
Amplitude Unit Vpp
Offset 0V
DC
Start Phase 0°
Square Duty Cycle 50%
Ramp Waveform Symmetry 50%
Pulse Duty Cycle 50%
Pulse Width 500μs
Pulse Leading Edge 20ns
Pulse Trailing Edge 20ns
Harmonic Type Even
Harmonic Order 2
Harmonic Phase (7) 0°
Harmonic Serial Number 2
Harmonic Amplitude (7) 1.2647Vpp